9 Step Guide to Check and Replace Your Hand Held Heat Welder Heat Element
If you notice that your hand welder takes longer to weld, only partially welds or has stopped welding completely, you may need to check and replace a heating element. Here's how to replace the element on your Leister Triac or BAK Rion hand-held heat welder:
- With the tool unplugged and cooled, remove the four mounting screws that hold the heater tube to the hand piece.
- Pull the heater tube away from the handle.
- Slide off the mica tube.
- Remove the gasket.
- Once the heating element is exposed, ﬁrmly grasp it in one hand and the green Triac or Rion handle in the other, and gently rock back and forth until the element comes off.
- Visually inspect the heating element for cracks or burn marks.
- Check the air ﬁlter and the heating element for blockages that may be restricting airﬂow.
- If the heating element appears faulty, youʼll need to replace it with a new one.
- To install a new element, or reattach the existing one, align the element prongs with the hand-gun sockets and plug the it into the hand piece. Firmly press together until snug and reassemble the tool.
Other Articles that may be of interest: 2 Simple Steps to Extend the Life of Your Hand Held Welder Heat Elements
A listing of heat welding tools and accessories can be found here.